XCentrick
02-22-2017, 10:26 PM
Recently, I bought a '59 Skyliner 332 CI equipped with AC and PS. I noticed the generator only had one belt attached but the pulley has two channels. One would think..."just add and run the second one in the same pattern as the one already on there". However, that second channel on the water pump is already being used. This leads me to think one or more of the belts are not correct and/or may not be routed right. Therefore, I would like to "Zerobase" this and get the right belts, channels and pattern(s).
Starting with the crank I would deeply appreciate if you could please give me the correct belt sequence front to rear. In addition, the correct routing including the right channel of each pulley for each belt.
If you don't have this info handy, do you know where I could get it? I haven't found any other '59 Skyliners I could look at to get the patterns in any car gatherings out here (So. Cal).
Best Regards and Very Much Appreciated.
Starting with the crank I would deeply appreciate if you could please give me the correct belt sequence front to rear. In addition, the correct routing including the right channel of each pulley for each belt.
If you don't have this info handy, do you know where I could get it? I haven't found any other '59 Skyliners I could look at to get the patterns in any car gatherings out here (So. Cal).
Best Regards and Very Much Appreciated.